ASHATA 3D Printer Break Detection Switch Filament Detecting Run-Out Pause Monitor Sensor Module 3D Printer Accessories

Use on board: the green light for the module is always on when material is available. When the material is used up, the green light goes out. The main board executes the pause command and waits for the personnel to replace the good mater main board wiring: M sensor port on the main board. For other boards: material detection module uses level jump detection method. When there is material, the level signal of the detection port should be high. When there is no material, the level signal of the material port becomes low, and the system detects one. If the high to low conversion is determined, the material is consider Suitable for 3D printer run-out, pause detection.