BaoFufc Manta M5P V1.0 Control Board 32Bit Integrated Motherboards for CB1 3D Printer Support for Klipper TMC2209 TMC5160 Integrated Motherboards

The new E-FUSE is equipped, which can respond quickly, enhance self-protection ability, and greatly reduce the motherboards burnout caused by short circuits. Manta M5P V1.0 Control board are born for Klipper running，designed with the same connector.Giving you a confident connection with all version of,and defintely CB1. a screw forced installation is available too. Matan M5P adopts 32Bit 64MHZ ARM Cortex-M0+Series-STM32G0B1RET6 chip, can also run without CB1.Support 5-axis stepper motor driver,Integrated UART modes of driver, easily configurable. Main board reserves switches interface expansion interface, supports selection, (24,12V, 5V) selection and for users use Klipper firmware to connect external acceleration sensor for acceleration compensation. Supports CAN Bus/Filaments runout sensor, Onboards interface port for connecting acceleration sensor to enable Klipper input shapings.