MetaHrystynx RC Helicopter, F150BL V3 Airwolf Remote Control Helicopter Model with LED Lights, With Altitude Hold and Strong Performance, RTF Version

Compared to the F150X, the F150BL V3 has the following upgrades: The biggest change is the complete upgrade of the remote control system, which applies GWYs (registered) high-end AHSS wireless frequency hopping control technology and protocol to the 150 small aircraft, redesigning and reshaping the appearance of the remote control. The new RC system is professional because the Air protocol supports up to 18 channels while for now only 5 channels are open on the airwolf and the other 13 channels are reserved for subsequent upgrades of functions. With receiver (GWY), this remote control can be applied to any fixed-wing model, cross plane, helicopter, car model, boat and so on. Note that the remote must be equipped with certain parts to activate 6 or more channels, such as switches, buttons, sliders, etc. LED lights were added to the tail of the helicopter. When the helicopter flies, the light turns on and off when it stops. LED lights are connected to the rear engine, which is installed on the tail of the fuselage. The bending angle of the rotary head tie rod set has been improved. The sensor process has been improved for the hardware, making it 20% more stable. In addition to the above structural optimization for performance improvement, the on-board nanny program is also optimized so that flight performance is improved by over 36%. A typical example is that no head lifting occurs on a constant speed route A specially customized battery bar is used to control the internal resistance value. Constrained by current battery technology, battery life has not been much improved., Manufacturer: MetaHrystynx