PeelAway 7 Paint Remover 750g

Peelaway 7 Paint & Varnish Remover removes multiple layers of most modern industrial and domestic coatings in one application. Its low-odour, methylene chloride-free, non-caustic paste is easy to use and naturally degradable. Suitable for intricate areas and surfaces including wood, plaster, brick, masonry and metal. It is also recommended for veneer, plywood and aluminium and is frequently architecturally specified. Do not use on certain plastics, including polycarbonate and Perspex. Test before use on unskimmed drywall. Always carry out a test patch before general use. Test areas should typically be 75 x 75mm to 300 x 300mm. Apply Peelaway paste 1-6mm thick depending on the coating type, age and number of layers. Place the Peelaway blanket print-side out onto the paste, rub gently to remove air and pierce any bubbles. Leave for 2-48 hours, depending on coating type and thickness. For areas involving different elevations several test patches should be applied to accommodate the possibility of different coatings and the effects of weather on exterior surfaces. To remove, the spatula should be inserted into the paste and a section gently lifted away. If the original surface is apparent, the test patch can be removed and the surface wiped with a damp sponge. If paint can still be seen, the test patch should be replaced and re-examined after a few hours. Once the correct paste and timing for the project has been established together with the thickness required, the designated paste should be applied, the Peelaway blanket laid over the paste and left for the time indicated by the test patch. Full instructions are on the container Each project can potentially give different results and this is why it is imperative to carry out Test Patches. Leaving on for not long enough could mean the process has not completed. Leaving on too long could damage the substrate or you may find the Peelaway blanket and paste becomes too hard and difficult to clean up.